Categories
Hand Operated Pinch Valves
Hand lever manual dispensing valves for controlled deposits of low to medium viscosity fluids such as Cyanoacrylate adhesives, UV cure, solvents, primers, activators, epoxies, PVA, etc. Takes a direct feed from a pressure pot, cartridge reservoir or syringe. Zero maintenance design for rapid change of clear or black plastic tubes. Accepts all luer lock tips.
Pneumatic Operated Pinch Valves
Air operated dispensing valves for making repeat dots or beads of most low to medium viscosity fluids such as Cyanoacrylate adhesives, UV cure, solvents, primers, activators, epoxies, PVA, etc. Takes a direct feed from a pressure pot, cartridge reservoir or syringe. Zero maintenance design allowing for rapid change of clear or black plastic tubes. Accepts all luer lock tips.
Pinch Valve Full Systems
Hand lever manual or air operated timed pinch valve systems for dispensing cyanoacrylate adhesives, UV cure or light sensitive, solvents, primers, activators, epoxies, PVA, and many more. Click here for systems supplied ready to use as a kit including a pressure pot, fluid lines, fittings, tips & a timed controller dispenser.
Pinch Tubes
Replacement pinch tubes for the TS1201 and TS1212 dispensing valves. Available in clear plastic for most standard adhesives, epoxies, solvents, primers, cyanoacrylates, inks, etc. and in opaque black for UV cure or light sensitive adhesives. Different types are available to select for each valve. Luer lock connections accept fluid lines and tips.
Fluid Lines
Flexible fluid lines and tubing for use with TS1201 and TS1212 dispensing valves. Available in a range of different diameters and types. In different colours to suit different liquids. Larger bore tubing allow the feed of more viscous adhesives without slowing down the flow rate. Use with our barbed luer lock fittings when connecting to the valves and needle tips.

Pinch Valves

 

Precision pinch tube valves for the controlled dispensing of low to medium viscosity fluids. Fluid is fed under pressure to the polyethylene tube inside the valve. This is "pinched" closed & opens up when dispensing. The tube is designed to last long periods and replacements are supplied in packs of 10. The benefit of these valves is that there is no potential of curable adhesives damaging the valve as the tube is just changed. Use with reactive adhesives and mixed epoxies.

Pinch tube dispensing valve

Pinch valves are ideal for dispensing most low to medium viscosity fluids. Using disposable pinch tubes eliminates the need for maintenance and cleaning. Low cost, quick to setup and easy to use. Whether dispensing by hand control or on a production line, pinch valves will handle cyanoacrylates, UV cure, anaerobics, inks, paints, solvents, primers and activators.
 
Use our valve selection guide page or click here for PDF datasheet selection guide.  Precision valves will dispense accurate deposits direct from syringes, cartridges or pressure pots.  Valves operate with minimal maintenance, ensuring clean and accurate dispensing whether used by hand, fixed on a production line or mounted onto an XYZ robot.
Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.